#!/bin/bash # Based on Adafruit Learning Technologies Onion Pi project # More info: http://learn.adafruit.com/onion-pi if (( $EUID != 0 )); then echo "This must be run as root. Try 'sudo bash $0'." exit 1 fi echo " $(tput setaf 2)              .~~.   .~~. $(tput setaf 6)   /         $(tput setaf 2)'. \ ' ' / .'$(tput setaf 6)         \ $(tput setaf 6)  |   /       $(tput setaf 1).~ .~~~..~.$(tput setaf 6)      \   | $(tput setaf 6) |   |   /  $(tput setaf 1) : .~.'~'.~. :$(tput setaf 6)   \   |   | $(tput setaf 6)|   |   |   $(tput setaf 1)~ (   ) (   ) ~$(tput setaf 6)   |   |   | $(tput setaf 6)|   |  |   $(tput setaf 1)( : '~'.~.'~' : )$(tput setaf 6)   |  |   | $(tput setaf 6)|   |   |   $(tput setaf 1)~ .~ (   ) ~. ~ $(tput setaf 6)  |   |   | $(tput setaf 6) |   |   \   $(tput setaf 1)(  : '~' :  )$(tput setaf 6)   /   |   | $(tput setaf 6)  |   \       $(tput setaf 1)'~ .~~~. ~'$(tput setaf 6)       /   | $(tput setaf 6)   \              $(tput setaf 1)'~'$(tput setaf 6)          / $(tput bold ; tput setaf 4)         Raspberry PiFi$(tput sgr0) " echo "$(tput setaf 6)This script will configure your Raspberry Pi as a wireless access point.$(tput sgr0)" read -p "$(tput bold ; tput setaf 2)Press [Enter] to begin, [Ctrl-C] to abort...$(tput sgr0)" echo "$(tput setaf 6)Updating packages...$(tput sgr0)" apt-get update -q -y echo "$(tput setaf 6)Installing hostapd...$(tput sgr0)" apt-get install hostapd echo "$(tput setaf 6)Installing ISC DHCP server...$(tput sgr0)" apt-get install isc-dhcp-server echo "$(tput setaf 6)Configuring ISC DHCP server...$(tput sgr0)" cp /etc/dhcp/dhcpd.conf /etc/dhcp/dhcpd.bak sed -i -e 's/option domain-name "example.org"/# option domain-name "example.org"/g' /etc/dhcp/dhcpd.conf sed -i -e 's/option domain-name-servers ns1.example.org/# option domain-name-servers ns1.example.org/g' /etc/dhcp/dhcpd.conf sed -i -e 's/#authoritative;/authoritative;/g' /etc/dhcp/dhcpd.conf echo -e "subnet 192.168.42.0 netmask 255.255.255.0 { range 192.168.42.10 192.168.42.50; option broadcast-address 192.168.42.255; option routers 192.168.42.1; default-lease-time 600; max-lease-time 7200; option domain-name \042local\042; option domain-name-servers 8.8.8.8, 8.8.4.4; }" >> /etc/dhcp/dhcpd.conf cp /etc/default/isc-dhcp-server /etc/default/isc-dhcp-server.bak sed -i -e 's/INTERFACES=""/INTERFACES="wlan0"/g' /etc/default/isc-dhcp-server echo "$(tput setaf 6)Turning off wlan0 if active...$(tput sgr0)" ifdown wlan0 echo "$(tput setaf 6)Updating network interfaces...$(tput sgr0)" mv /etc/network/interfaces /etc/network/interfaces.bak echo "auto lo iface lo inet loopback iface eth0 inet dhcp allow-hotplug wlan0 iface wlan0 inet static address 192.168.42.1 netmask 255.255.255.0 " > /etc/network/interfaces echo "$(tput setaf 6)Assigning static IP address 192.168.42.1...$(tput sgr0)" ifconfig wlan0 192.168.42.1 echo "$(tput setaf 6)Configuring hostapd...$(tput sgr0)" echo "$(tput bold ; tput setaf 2)Type a 1-32 character SSID (name) for your PiFi network, then press [ENTER]:$(tput sgr0)" read ssid echo "$(tput setaf 6)PiFi network SSID set to $(tput bold)$ssid$(tput sgr0 ; tput setaf 6). Edit /etc/hostapd/hostapd.conf to change.$(tput sgr0)" pwd1="0" pwd2="1" until [ $pwd1 == $pwd2 ]; do echo "$(tput bold ; tput setaf 2)Type a password to access your PiFi network, then press [ENTER]:$(tput sgr0)" read -s pwd1 echo "$(tput bold ; tput setaf 2)Verify password to access your PiFi network, then press [ENTER]:$(tput sgr0)" read -s pwd2 done if [ $pwd1 == $pwd2 ]; then echo "$(tput setaf 6)Password set. Edit /etc/hostapd/hostapd.conf to change.$(tput sgr0)" fi echo "interface=wlan0 driver=rtl871xdrv ssid=$ssid hw_mode=g channel=6 macaddr_acl=0 auth_algs=1 ignore_broadcast_ssid=0 wpa=2 wpa_passphrase=$pwd1 wpa_key_mgmt=WPA-PSK wpa_pairwise=TKIP rsn_pairwise=CCMP" > /etc/hostapd/hostapd.conf echo "$(tput setaf 6)Setting hostapd to run at system boot...$(tput sgr0)" cp /etc/default/hostapd /etc/default/hostapd.bak sed -i -e 's/#DAEMON_CONF=""/DAEMON_CONF="\/etc\/hostapd\/hostapd.conf"/g' /etc/default/hostapd echo "$(tput setaf 6)Setting IP forwarding to start at system boot...$(tput sgr0)" cp /etc/sysctl.conf /etc/sysctl.bak echo "net.ipv4.ip_forward=1" >> /etc/sysctl.conf echo "up iptables-restore < /etc/iptables.ipv4.nat" >> /etc/network/interfaces echo "$(tput setaf 6)Activating IP forwarding...$(tput sgr0)" sh -c "echo 1 > /proc/sys/net/ipv4/ip_forward" echo "$(tput setaf 6)Setting up IP tables to interconnect ports...$(tput sgr0)" iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADE iptables -A FORWARD -i eth0 -o wlan0 -m state --state RELATED,ESTABLISHED -j ACCEPT iptables -A FORWARD -i wlan0 -o eth0 -j ACCEPT echo "$(tput setaf 6)Saving IP tables...$(tput sgr0)" sh -c "iptables-save > /etc/iptables.ipv4.nat" echo "$(tput setaf 6)Fetching Adafruit's updated access point software...$(tput sgr0)" wget http://www.adafruit.com/downloads/adafruit_hostapd.zip echo "$(tput setaf 6)Decompressing adafruit_hostapd.zip...$(tput sgr0)" unzip adafruit_hostapd.zip echo "$(tput setaf 6)Updating hostapd...$(tput sgr0)" mv /usr/sbin/hostapd /usr/sbin/hostapd.ORIG mv hostapd /usr/sbin chmod 755 /usr/sbin/hostapd echo "$(tput setaf 6)Cleaning up...$(tput sgr0)" rm adafruit_hostapd.zip echo "$(tput setaf 6)Starting hostapd service...$(tput sgr0)" service hostapd start echo "$(tput setaf 6)Starting ISC DHCP server...$(tput sgr0)" service isc-dhcp-server start echo "$(tput setaf 6)Checking hostapd status...$(tput sgr0)" service hostapd status hostapd_result=$? #if [ $hostapd_result == 3 ]; then # echo "ERROR: hostapd start failed." # exit 1 #fi echo "$(tput setaf 6)Checking ISC DHCP server status...$(tput sgr0)" service isc-dhcp-server status dhcp_result=$? #if [ $dhcp_result == 3 ]; then # echo "ERROR: ISC DHCP server failed to start." # exit 1 #fi echo "$(tput setaf 6)Setting hostapd to start on system boot...$(tput sgr0)" update-rc.d hostapd enable echo "$(tput setaf 6)Setting ISC DHCP server to start on system boot...$(tput sgr0)" update-rc.d isc-dhcp-server enable echo "$(tput setaf 6)Removing WPASupplicant...$(tput sgr0)" mv /usr/share/dbus-1/system-services/fi.epitest.hostap.WPASupplicant.service ~/ echo "$(tput setaf 6)Rebooting...$(tput sgr0)" reboot exit 0